888-4TE-WIRE (888-483-9473)


Reference Standards

TE Wire & Cable supplies products and services to meet a variety of
industry and customer specifications. Many are listed below.



AMS
ANSI
ASTM
BAC
CSA
IEC
IEEE
ISO
MIL STD
NCSL
NEC
UL


.
AMS 2750
ANSI MC96.1
ANSI/NCSL Z540-1

ASTM E207
ASTM E 220
ASTM E 230

BAC-5621
CSA-C22.2 No. 239
IEC 584
IEEE 383
IS0 Guide 25

ISO 9001-2000
MIL-STD-105
MIL-STD-45662A
NEC Article 340
NEC Article 501
NEC Article 725
NEC Article 727
UL 13
UL 62
UL 83
UL 1277
UL 1581
UL 2250
Abbreviations

Aerospace Material Specification
American National Standard Institute
American Society of Testing and Materials
Boeing Aircraft Corporation
Canadian Standards
International Electrotechnical Commission
Institute of Electrical and Electronic Engineers
International Standards Organization
Military Standard
National Conference of Standard Laboratories
National Electrical Code
Underwriters Laboratories

Specifications

Pyrometry
Temperature Measurement Thermocouples
Calibration Laboratories and Measuring and Test Equipment
General Requirements
Thermal EMF Test of Single Thermoelement Materials
Calibration of Thermocouples by Comparison Techniques
Standard Specification and EMF Tables for Standardized
Thermocouples
Temperature Control For Processing Materials
Control and Instrumentation Cable
Thermocouples
Standard Test for Class 1E Cables for Nuclear Generation Stations
General Requirements for the Competence of Calibration and
Testing Laboratories
ISO 9001-2000 Quality Management
Sampling Procedures and Tables for Inspection by Attributes
Calibration System Requirements
Power and Control Tray Cable
Class 1 Locations
Remote-Control, Signaling and Power-Limited Circuits
Instrumentation Tray Cable
Power-Limited Circuit Cable
Flexible Cord and Fixture Wire
Thermoplastic-Insulated Wires and Cables
Electrical Power and Control Tray Cables
Reference Standard for Electrical Wires, Cables, and Flexible Cords
Instrumentation Tray Cable

* Thermocouple material is normally supplied to meet tolerances above 0C (32F). If material is required to meet tolerances below 0C (32F), the purchase order must so state. Special selection of material is required.

** Suggested initial calibration tolerance. Requirements should be discussed between purchaser and supplier.

*** Copper vs. copper can be used as an extension for Type B thermocouples if the transition is below 100C (212F). Above 100C (212F), PCLW30-6 alloy should be used as the positive extension wire.